Navigation Menu+
Commercial Flooring News

Proper Applying Of Wood Finishes – Hacks

Usually London flooring procedures are ended by applying wood finishes. These finishes are specially tailored to protect the floor surface and to show the best appearance of wood. In order to achieve the best possible finish, follow the hacks of Craig Pawson, who is flooring specialist at Osmo UK.

  • Step 1: preparation of the surface of the London flooring. This preparative phase should not be neglected. In case the surface is not ready for the application of the seal, then the London flooring procedure will be inefficient, because the finish won’t be properly absorbed. Don’t make this mistake, because you may decrease the life of the finish.
  • Step 2: sanding procedure. All London flooring experts know that selecting the appropriate sanding technique is crucial for the quality of the surface and its subsequent appearance. The way of London flooring preparation depends on the surface current condition. Sometimes, it may be needed to begin with super rough grade of sandpaper (40 grit) or a little finer, 60-80 grit with using a belt grinder. If the London flooring is very old and damaged, then the initial sanding procedure have to be rougher (24 grit). London flooring experts advise to undertake a trial sanding before sanding the entire area. When it comes to final sanding session, London flooring specialists advise sanding between 120 grit and 150 grit, using a single or multi-disc buffing equipment.
  • Step 3: getting rid of the sanding leftovers. London flooring contractors achieve sleek and glossy surface by removing all sanding residues. London flooring experts advise to remove all the dust carefully in order to achieve maximum agglutination of the finish.
  • Step 4: preparation for application of the finish. According to London flooring contractors, there are many products that don’t require a primer. This way time and money are saved. In addition, the final look of the London flooring is more natural.
  • Step 5: choosing the right type of applicator. In this case, the necessary tool is defined depending on the finish used. In case the finish is oil-based, then a natural bristle brush or even a roller are quite appropriate. There is also a water-based finish which is best applied by a synthetic brush.
  • Step 6: application of the finish. London flooring experts advise you to apply 2 very thin layers. It is essential to let each layer dry entirely before beginning the next. London flooring specialists apply thinly and equally on the wood grain, by using a natural bristle brush or microfibre roller, and spread very well. Excellent ventilation whilst drying must be ensured. After that the second coating may be applied on the dry and clean surface. London flooring contractors claim that the final surface quality is influenced also by the wood’s surface structure.

Follow these steps and apply properly wood finishes!

Inspired by www.contractflooringjournal.co.uk