Navigation Menu+
Commercial Flooring News

Vinyl Floor Tiles

Vinyl floor tiles are, hands down, the fastest and easiest way to spruce up a kitchen or bathroom. But in the event of remodeling, this means that you already have a floor – good or bad–in place. This begs the questions: “Should you remove that floor? If not, can you get by with leaving it?”

In many cases, you can install vinyl floor tiles on top of your present floor, but it depends on what type of floor you already have and what shape it is in.

If the present floor is something like sheet vinyl, I recommend that you take a deep breath and just remove it.

In general, it’s more difficult to put vinyl over tile than the opposite–installing tile over vinyl.

Smooth and Seamless Is Best

Any kind of smooth, seamless or tightly seamed surface works well for vinyl floor tile: sheet vinyl, linoleum, etc.

You can install vinyl floor tiles over ceramic tiles, provided that the grout lines are not too wide or deep. Wide grout lines will eventually show through–or to use industry lingo, “telegraph” through the vinyl.

Wood flooring can also accept vinyl tiles, but it’s not the best. The optimum condition is to have a substrate of one-quarter inch plywood or other smooth underlayment, rather than flooring.

How To Do It

1. With a chalk snap line and a measuring tape, measure the center points of all four walls. Snap a chalk line between facing walls, so that a cross is formed. Begin laying the tiles from the center point, and working outward within one of the quadrants (it doesn’t matter which one you begin with).

3. Fill the remaining three quadrants, also leaving the tile/wall gap.

4. Now, it’s time to fill the gaps. Lay a full tile across the gap. A portion should overlap the outer edge of your vinyl tiles. With a carpenter’s pencil, mark on the loose tile where the edge of the laid tiles fall.

5. With a straight edge, draw a line between the two marks.

6. Using the straight edge again, cut down the line with a utility knife. You may have to cut twice to slice all the way through. Don’t cut on top of your new tile floor! Do this on top of a sheet of plywood or thick cardboard.

7. Strip the paper backing from the tile and install it.